Front brake pad costs and warning signs (Honda City)

整理中beginner

15 minutes~RM 260配件与工时 · 截至 2026年10月26日5 steps

If the pedal sinks toward the floor or the car pulls to one side when you brake, stop driving and get it checked

Grinding that follows wheel speed means the pad material is gone. Do not keep driving on it

Ask for the old pads back so you can see how much material was left

所需工具: Flashlight

Steps

Note what the car does when you brake

Tip: Squeal, grinding, a longer pedal, or a shimmy through the wheel. Each one points somewhere different

Look at the pad through the wheel

Warning: Solid hubcaps hide the pads. Ask for a check at your next tyre rotation instead of guessing

Tip: Torch between the spokes at the caliper. New pads carry about 10mm of material; below 3mm, book the job

Work out how urgent it is

Tip: Grinding with a long pedal means stop now. A squeal with a firm pedal gives you a week or two, not a month

Get two quotes on the same job

Tip: Ask for front pads fitted, discs checked, and a separate price for discs if they are scored. Compare totals, not pad brands

Book it and ask for the old parts

Tip: The work itself takes two to three hours. Leave the car for half a day so the discs can be measured on the lift

The City is heavier than a national hatchback and its pads are dearer, so this is the job where a quote can swing by a hundred ringgit. You do not need to touch a caliper. You do need to know what is in the quote.

What it should cost

Item	Band
Front pad set, per axle	RM90 to RM160
Labour, front axle	RM50 to RM90
Typical total, one axle	RM180 to RM330
Add if the discs are scored	RM100 to RM150 labour, plus discs

OEM pads sit at the top of the parts band. An aftermarket set from a known maker sits at the bottom and is fine for normal driving. Ask which one is in the quote before you compare totals, because two workshops can quote the same job with a RM70 gap and both be fair.

These are ranges from Malaysian workshop price lists, checked 2026-10-26. Your town and the pad brand move them.

What to watch for

Pads that squeal from the first day usually went in dry, or without shims. Take the car back rather than living with it.
Judder through the pedal after the job is a disc or bed-in problem, not a pad problem.
A quote for calipers on both sides, on a car that brakes straight, is often an upsell. Calipers do fail, but not usually in pairs at 60,000km.
Insist on the disc thickness being measured, not eyeballed.

What to ask for

Front pads on both sides, and the old parts back in the box.
Disc thickness in millimetres, written on the invoice.
Pads with shims, and the brand named before they start.
A short test drive before you pay, so any judder shows up while you are still there.

If you keep driving

A worn pad still stops the car. A worn pad on a scored disc stops it less well, and costs more to put right. On a heavier car the difference in stopping distance shows up sooner than you expect.